A Mainspring company - serving Whitney, NV

Genie Cable & Drum Replacement in Whitney, NV

Raised-panel steelRaised-panel steel
Carriage houseCarriage house
Modern flushModern flush
Full-view glassFull-view glass
LiftMaster openersLiftMaster openers
Chamberlain openersChamberlain openers
Every visit starts with

Full 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included

We have financing partners for your new garage door*On approved credit; ask us about your options

You get a price before we start. It does not change when the pro arrives.

Get your free estimate

Genie Cable & Drum Replacement: The Whitney Owner’s Guide

Genie-compatible cable and drum replacement runs $130 to $250 installed in Whitney, and most jobs are finished the same day you call. We match the drum and cable to your Genie’s door weight and track setup, quote the flat price before any work starts, and back the work in writing for 90 days. Same-day availability applies to a failed cable or slipping drum you’re dealing with right now.

Call (844) 797-9248

Owners usually find this one the hard way. The door comes down crooked and won’t sit flat. One side looks slack while the other is drum-tight. Or the drum starts winding cable unevenly and the door climbs with a grinding hitch. On Genie screw-drive and chain-drive units the cable and drum fail slowly, so the first sign is often a door that has drifted out of level by an inch or two. By the time it’s obvious, the cable is usually a strand or two from letting go. In Whitney’s dry heat, cable and drum wear tends to show up first on doors facing full afternoon sun.

Key Takeaways

  • Installed Genie cable and drum replacement in Whitney runs $130 to $250.
  • Both drums and both cables are replaced together. One rarely fails alone.
  • Cables carry the door’s full weight under tension. This is not a homeowner job.
  • We quote the flat price before work begins, so there are no surprises on the bill.
  • Every job is covered by our 90-Day Done Right Promise, in writing.

Which Genie Models This Applies To

Genie cable and drum assemblies turn up on nearly every residential Genie we see around Whitney: the screw-drive and chain-drive openers paired with sectional doors, including the quiet belt-driven models. The opener matters less. What actually decides the part is the door itself. A Genie drum is cut for a specific door height and a specific track radius. A seven-foot door with a twelve-inch-radius track uses a different drum from an eight-foot door with a fifteen-inch track, even though they look nearly identical on the shelf. Put the wrong one on and the cable won’t run true, which wears the drum and cable down fast.

To identify the correct part, check the door height (measure from the floor to the top of the opening), the track curve, and the door’s weight class. The sticker on the opener tells you the opener model; the door manufacturer’s label on a panel tells you the door. Both matter. We keep a light and a tape measure ready when you call, so you can read us what’s stamped on the door and we can tell you which assembly you need. For Genie specifically, the drum-and-cable assemblies carry their own part numbers distinct from multi-brand hardware. OEM Genie drums are available, and so are quality aftermarket equivalents that fit the same doors. We’ll tell you plainly which one makes sense for a door your age.

We’re an independent service provider, not affiliated with Genie. That means we’re loyal to your door, not a parts catalog. We service other brands too, including LiftMaster and Chamberlain, in case a second door on the property needs attention. When we quote a Genie part, it’s because it’s the right part, not because it’s the only one we stock.

Explore

Styles & brands we work with

  • Raised-panel steel
  • Carriage house
  • Modern flush
  • Full-view glass
  • LiftMaster openers
  • Chamberlain openers

Signs Your Genie Cable & Drum Replacement Is Failing

  • Door won’t sit level. One side hangs an inch or more lower because that cable has stretched or slipped on its drum. The drum winds unevenly once the cable loses its seat, and the door racks out of square.
  • Visible fray or kink in the cable. Frayed strands mean the cable is near failure. A single broken strand can jump the pulley and jam the door mid-travel.
  • Drum grinding or clicking. A worn drum’s spiral groove fills with debris or chips, so the cable can’t lay flat. That clicking you hear is the cable snapping between turns.
  • Door slams or free-falls. This usually points to a spring problem, but a drum that has let go can drop the door just as fast. Stop using the door until someone has looked at it.
  • Slack cable hanging in the track. A cable off its drum will sag or wrap around the torsion bar. Don’t reach for it. That’s the point where it’s dangerous.

One Whitney-specific reality: the dry desert air pulls moisture from wood and steel alike, and cables that sit under near-constant tension can corrode quietly at the drum edge where you can’t see them. A quick visual check of both cables once a season catches most of this before it becomes a crooked door.

Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Replacement Cost & What’s Included

For a residential Genie door in Whitney, cable and drum replacement generally falls between $130 and $250 installed. The price depends on door height, the drum radius, whether the door is single or double, and whether we’re replacing both cables and both drums or one assembly. We replace cables and drums in matched pairs because mismatched wear is what causes the next failure.

Item Whitney Price Range
Cable repair (one side) $130 – $250
Cable & drum replacement, matched pair $130 – $250
Spring repair (if springs are also worn) $180 – $340
Roller replacement (paired with new cables) $110 – $220

The quote includes the drums, the cables, the labor, and a return visit if anything isn’t right under our 90-Day Done Right Promise. It’s in writing on every job and there’s no dispute process. We tell you the flat price before any work begins, so a failed drum never turns into a surprise on the bill. If your springs are also worn, tell us when you call and we’ll price both in one visit.

$50 Off Any Repair Over $250

Anything that lands over $250, including a combined cable-and-spring job, gets $50 off. Ask about it when you call, and we’ll apply it to the estimate.

DIY or Call Us?

Here’s the honest line. You can safely check the door from the ground: look for a slack cable, a crooked panel, or a grinding drum. Stop there. Cables and drums carry the door’s full weight on a torsion system under extreme tension. A cable that lets go can do real damage to a hand, a wrist, or worse. This isn’t a parts-swap a homeowner can do with YouTube confidence, and we’d rather you not try it.

What you can do is call us at (844) 797-9248. Our phones are answered by a live person around the clock, including nights and weekends, so you won’t hit voicemail or a phone tree. We’ll walk you through what to look for from the floor, tell you a flat price for the Whitney job, and schedule the visit. Our technicians have up to 10 years of experience and come background-checked and uniformed. If it’s a cable-or-drum failure you’re facing now, we can often get out the same day.

FAQs

Need Garage Door help nationwide? Licensed & insured · 30-60 min response · free estimates
Call (844) 797-9248
Local Service Coverage

Request a Free Estimate in Whitney

Tell us what you need - Mainspring Garage Door Co. Whitney responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Text Us
Call Now - 24/7 Dispatch